In the image below it shows a mini split with the line set running up which is okay.
Mini split lineset in attic.
Install two mitsubishi sez model ducted minisplits in the attic.
Both the conventional ac unit and the mini unit are in a big cage bolted to the side wall of the crawl.
Ultimately a diy mini split in spray foam attic works best for relative humidity control in my situation.
Putting your ductless mini split condenser in your attic is not recommended.
Other end of lines went across the walk in crawl to the outside.
It will be more costly to run the linesets in the crawlspace and definitely easier to run them in the attic.
Slim comes to mind.
Diy mini split install in spray foam attic.
Private email 2016 03 24 click to enlarge any image shown at left.
In the walls in the basement in the eaves or soffit as long as you take care with the insulation it should be fine.
Secure the pipe as often as possible at least every four feet.
The contractor uses pmd gelcopper insulation instead of the mitsubishi type.
The condenser which is also known as the compressor is an outdoor unit.
An hvac contractor has taken a look at the house and has a recommendation inverter explains in this q a post.
One will cool the master bedroom the other will cool the two bedrooms where inverter s children sleep.
A ductless mini split heat pump and ac not only adds conditioned air but also removes moist air dehumidifies.
That aside is one space better than the other to locate the lines.
My installer is willing to run the linesets in either the attic or crawl for my minisplit.
You can run a ductless line set up down or straight out.
Some mini split wall tumors have a spring already installed on the flare stubs mitsubishi s mr.
Just did one last week.
The attic at inverter s house is.
And while i have run more than a bit of linehide i personally try to hide the lineset as much as possible.
To explain why let s talk a bit about what the mini split condenser is and how it works.
Your condenser works in conjunction with the indoor units or the mini splits themselves.
Lineset wire and drain went up through a wall and in the attic to the back of the wall where the head was installed.
Is making the switch a good idea.